003 File Manager
Current Path:
/usr/src/tests/sys/cddl/zfs/tests/interop
usr
/
src
/
tests
/
sys
/
cddl
/
zfs
/
tests
/
interop
/
📁
..
📄
Makefile
(377 B)
📄
cleanup.ksh
(1.81 KB)
📄
interop.cfg
(2.33 KB)
📄
interop_001_pos.ksh
(2.77 KB)
📄
interop_test.sh
(1.57 KB)
📄
setup.ksh
(2.47 KB)
Editing: setup.ksh
#!/usr/local/bin/ksh93 -p # # CDDL HEADER START # # The contents of this file are subject to the terms of the # Common Development and Distribution License (the "License"). # You may not use this file except in compliance with the License. # # You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE # or http://www.opensolaris.org/os/licensing. # See the License for the specific language governing permissions # and limitations under the License. # # When distributing Covered Code, include this CDDL HEADER in each # file and include the License file at usr/src/OPENSOLARIS.LICENSE. # If applicable, add the following below this CDDL HEADER, with the # fields enclosed by brackets "[]" replaced with your own identifying # information: Portions Copyright [yyyy] [name of copyright owner] # # CDDL HEADER END # # $FreeBSD$ # # Copyright 2009 Sun Microsystems, Inc. All rights reserved. # Use is subject to license terms. # # ident "@(#)setup.ksh 1.5 09/06/22 SMI" # . $STF_SUITE/include/libtest.kshlib verify_runnable "global" case $DISK_COUNT in 0) log_untested "Need at least 1 disk device for test" ;; 1) log_note "Partitioning a single disk ($SINGLE_DISK)" ;; 2) log_note "Partitioning a disks ($SINGLE_DISK) and ($ZFS_DISK2)" ;; 3) log_note "Partitioning disks ($META_DISK0 $META_DISK1 $ZFS_DISK2)" ;; esac wipe_partition_table $META_DISK0 log_must set_partition ${META_SIDE0##*s} "" $FS_SIZE $META_DISK0 if [[ $WRAPPER == *"smi"* && $META_DISK1 == $META_DISK0 ]]; then typeset i=${META_SIDE0##*s} typeset cyl=$(get_endslice $META_DISK0 $i) log_must set_partition ${META_SIDE1##*s} "$cyl" $FS_SIZE $META_DISK1 else log_must set_partition ${META_SIDE1##*s} "" $FS_SIZE $META_DISK1 fi if [[ $WRAPPER == *"smi"* && $ZFS_DISK2 == $META_DISK1 ]]; then typeset i=${META_SIDE1##*s} typeset cyl=$(get_endslice $META_DISK1 $i) log_must set_partition ${ZFS_SIDE2##*s} "$cyl" $FS_SIZE $ZFS_DISK2 else log_must set_partition ${ZFS_SIDE2##*s} "" $FS_SIZE $ZFS_DISK2 fi create_pool $TESTPOOL $ZFS_SIDE2 $RM -rf $TESTDIR || log_unresolved Could not remove $TESTDIR $MKDIR -p $TESTDIR || log_unresolved Could not create $TESTDIR log_must $ZFS create $TESTPOOL/$TESTFS log_must $ZFS set mountpoint=$TESTDIR $TESTPOOL/$TESTFS log_must $ZFS set compression=off $TESTPOOL/$TESTFS log_note "Configuring metadb with $META_SIDE1" log_must $METADB -a -f -c 3 $META_SIDE1 log_note "Configure $META_DEVICE_ID with $META_SIDE0" log_must $METAINIT $META_DEVICE_ID 1 1 $META_SIDE0 log_pass
Upload File
Create Folder