003 File Manager
Current Path:
/usr/src/sys/contrib/device-tree/Bindings/net/can
usr
/
src
/
sys
/
contrib
/
device-tree
/
Bindings
/
net
/
can
/
📁
..
📄
allwinner,sun4i-a10-can.yaml
(1.03 KB)
📄
atmel-can.txt
(400 B)
📄
bosch,m_can.yaml
(3.91 KB)
📄
c_can.txt
(1.97 KB)
📄
can-transceiver.yaml
(496 B)
📄
cc770.txt
(1.59 KB)
📄
fsl-flexcan.txt
(1.89 KB)
📄
grcan.txt
(957 B)
📄
holt_hi311x.txt
(663 B)
📄
ifi_canfd.txt
(369 B)
📄
microchip,mcp251x.txt
(743 B)
📄
mpc5xxx-mscan.txt
(1.64 KB)
📄
rcar_can.txt
(3.42 KB)
📄
rcar_canfd.txt
(3.63 KB)
📄
sja1000.txt
(1.75 KB)
📄
tcan4x5x.txt
(1.35 KB)
📄
ti_hecc.txt
(992 B)
📄
xilinx_can.txt
(1.96 KB)
Editing: tcan4x5x.txt
Texas Instruments TCAN4x5x CAN Controller ================================================ This file provides device node information for the TCAN4x5x interface contains. Required properties: - compatible: "ti,tcan4x5x" - reg: 0 - #address-cells: 1 - #size-cells: 0 - spi-max-frequency: Maximum frequency of the SPI bus the chip can operate at should be less than or equal to 18 MHz. - interrupt-parent: the phandle to the interrupt controller which provides the interrupt. - interrupts: interrupt specification for data-ready. See Documentation/devicetree/bindings/net/can/bosch,m_can.yaml for additional required property details. Optional properties: - reset-gpios: Hardwired output GPIO. If not defined then software reset. - device-state-gpios: Input GPIO that indicates if the device is in a sleep state or if the device is active. - device-wake-gpios: Wake up GPIO to wake up the TCAN device. Example: tcan4x5x: tcan4x5x@0 { compatible = "ti,tcan4x5x"; reg = <0>; #address-cells = <1>; #size-cells = <1>; spi-max-frequency = <10000000>; bosch,mram-cfg = <0x0 0 0 32 0 0 1 1>; interrupt-parent = <&gpio1>; interrupts = <14 GPIO_ACTIVE_LOW>; device-state-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>; device-wake-gpios = <&gpio1 15 GPIO_ACTIVE_HIGH>; reset-gpios = <&gpio1 27 GPIO_ACTIVE_HIGH>; };
Upload File
Create Folder